Part Number: 120889-00 Rev. 01
1
Summit X460-G2 Series Switches
Installation Note
Pre-installation Requirements
Before you install the Summit X460-G2 series switch, read the information in “Safety Information” on
page 2.
The following items are provide with the Summit X670 series switch:
● Mounting brackets
● Eight M3 screws to secure the mounting brackets to the switch
To install the switch in a rack, you need the following additional tools and equipment:
● Four rack mounting screws to match your equipment rack
● Screwdriver to fit the rack mounting screws
● AC power cord that is suitable for the current rating of this product (See “Selecting AC Power
Supply Cords” on page 4.
Required Tools
The following items are provided with the Summit X460-G2 series switch:
● Two rack mounting brackets adaptable for either a front-mount or mid-mount installation
● Twelve screws for attaching the brackets to the switch enclosure
● For DC models, spade terminal and M4 screw with captive washer for grounding the switch
You need the following additional tools and materials to install the switch in a rack:
● #1 Phillips screwdriver
● Four rack mounting screws to match your equipment rack
● Screwdriver to fit the rack mounting screws
● #14 AWG stranded copper cable for grounding the switch (DC powered models)
● ESD-preventive wrist strap for installing optional ports at the back of the switch
To Next Page
Need help?
General
