Eyecon EC1500 - TROUBLE SHOOTING; CAMERA NOT RESPONDING; SD CARD ISSUES

17
PLEASE REGISTER TO ACTIVATE YOUR PRODUCT’S WARRANTY.
NOTE: The Storm is designed with a low battery voltage shut down to ensure
maximum camera performance. For example if your camera was in use for
several weeks or months and you push the power button to wake it up you
may notice a FlashingBatteryWarning that says, “Change Batteries.” There
will also be a picture of a battery icon with a RED X in the center. The only way
to clear the battery warning is to remove and replace the batteries.
TROUBLE SHOOTING
CAMERA NOT RESPONDING: If your camera at anytime does not respond
when the buttons are pushed or you cannot turn it o, your camera may be
locked up. The best way to resolve this problem is to open one of the battery
doors for a period of 10 seconds. This will cut the main power supply to the
camera and will take care of the problem. If you are using both the external
ECA100 Extenda-Life lithium Battery Pack and internal Alkaline supply,
you will need to do the same for both.
BAD SDHC CARD: Over time a SDHC or any storagedevice could become
corrupt. If your camera fails to acknowledge the SDcard we recommend that
you replace the card with a new SDcard or one from a dierent EYECON™
Trail Camera that you know works. This will help determine whether the
problem is the SDcard or the camera. We do NOT recommend using cards
that have been used in cameras from dierent companies and/or dierent
styles of cameras.
NOTE: It is recommended not to use a card that has been previously used in
dierenttrailcameras or one that has previously been used in a Point&
ShootCamera unless it is rst formatted. It is also not recommended to view