16
SAFETY
Tires
Operating the vehicle with the incorrect tires or with the incorrect or uneven tire pressure can cause loss of control or
an accident. Always use the size and type of tires specified for the vehicle. See Vehicle Specification for proper tire
type and size. Always maintain the correct tire pressures as specified in Tire Pressure on page 13.
Slippery Terrain
Driving on rough, wet, or loose terrain increases the risk of loss of traction or control and accident or rollover. Drive
slowly and use the correct turning procedures when operating on slippery surfaces.
Tires that have lost traction and then regain traction suddenly can cause loss of vehicle control or rollover.
Refer to Slippery Surfaces on page 27 for operational information.
BATTERY CHARGING
Charging should be performed when ambient temperatures are between 40°F and 110°F (4°C and 42°C). The battery
pack may be charged or topped off after every use.
The battery management system (BMS) and charger cooperate to make sure that charging occurs at the proper rate
for the battery temperature. When the battery charger is connected to the vehicle, it will determine the charge rate
based on the battery temperature. The charger will operate at the rates shown in the table below.
The BMS will adjust the charge rate based on the temperature of the batteries.
Use only the OEM approved Lithium-Ion battery charger for your vehicle. See charger operating instructions in Appen-
dix A.
• Turn the key to the OFF position and remove it.
• Inspect the charger cord for cracks, frayed wires or loose connections, if damaged, replace it.
• Inspect the vehicle charger receptacle and charger plug for dirt, debris or damage. Clean if necessary and replace
immediately if damage is found.
• Connect the charger to a wall receptacle. Do not use a multi-plug adapter or power strip. Do not connect anything
else to the same receptacle.
• Connect the charger to the vehicle receptacle.
• When the battery pack is finished charging, disconnect the charger cord from the vehicle. If disconnecting before
the charge cycle is complete, it is recommended that the charger be disconnected from the wall receptacle first,
then unplug the charger from the vehicle receptacle.
VEHICLE LIFTING
The vehicle must be on a firm and level surface for lifting. Remain constantly aware that the vehicle is not stable
during the lifting process. Do not get under a vehicle until you verify that it is stable on the jack stands. Never get
under a vehicle while it is on a jack only. Put wheel chocks in front of and behind the wheels that are not being lifted.
Do not allow anyone to remain or get on the vehicle at any time during the lifting process.
Read and comply with all warnings and follow the lifting procedures described on page 34.
VEHICLE MODIFICATION
Removing some items from the vehicle can change the designed handling characteris-
tics and present a significant safety risk.
Do not install any accessory not approved by E-Z-GO. Do not modify the vehicle to increase the speed or power. Any
modifications or installation of accessories not approved by TSV can create a safety hazard and increase the risk of
injury.
The warranty will be terminated if the vehicle is modified to increase vehicle speed or power.
The warranty may be terminated if the original (or equivalent) replacement parts are not installed on the vehicle.
The addition of some accessories can change the handling characteristics of the vehicle. Use only E-Z-GO approved
accessories, and familiarize yourself with their function and effect on the vehicle.
Charge Rate Temperature
NO charging below 14° F (-10°C) or above 140°F (60°C)
Pre-charge (charge at reduced rate, 6 amps) between 14°F (-10°C) and 41°F (5°C)
between 104°F (40°C) and 140°F (60°C)
Full charging between 37.4°F (3°C) and 107.6°F (42° C)
To Next Page
Loading...
Need help?
General
