OPERATION
25
Anti-Roll Back Feature
Anti-Roll Back, like Walk-Away, limits reverse motion of the vehicle down a slope to less than 2 mph (3 kph). See
Walk-Away Feature for more information. An alarm will not be activated should the anti-roll back feature engage.
Anti-Stall Feature
Anti-Stall protection prevents motor damage if the vehicle is stalled against an object or on a hill.
Example: If all of the following events occur:
• the system senses that the accelerator pedal is pressed (power applied to motor)
• the motor is stopped long enough that additional time can cause damage to the motor
the Anti-Stall feature will interrupt power to the motor. To restore power to the motor, flip the RUN/TOW switch to
“TOW” position and then return the switch to “RUN” position.
High Pedal Disable Feature
High Pedal Disable prevents acceleration of the vehicle if the direction selector is changed or the key is turned on
while the accelerator is pressed.
Diagnostic Mode Feature
Diagnostic mode helps with troubleshooting.
With some electrical system failures, the Diagnostic Mode feature defaults to a mode that allows the vehicle to oper-
ate at a decreased speed.
This feature allows you to return the vehicle to the storage facility and identify the problem.
STARTING AND STOPPING THE VEHICLE
Unintentional roll-back of the vehicle could cause severe personal injury or vehicle dam-
age. To reduce the possibility of vehicle roll-back, keep the brake fully pressed until the
motor has started.
All vehicles have an interlock system that disables the controller and prevents operation of the vehicle while the char-
ger is connected. Remove the charger plug from the receptacle and correctly store the cord before you move the vehi-
cle.
1. Sit in the driver’s seat.
2. Press and hold the brake pedal.
3. Insert the key and turn to the desired direction.
NOTICE: When the direction selector is moved to the reverse position, a warning alarm will activate to indi-
cate that the vehicle is ready to run in reverse.
4. Slowly press the accelerator pedal to start the motor.
5. When the accelerator pedal is released, the motor decreases the speed of the vehicle. To stop the vehicle more
quickly, press the brake pedal.
6. Engage the parking brake, turn the key to OFF and remove the key from the switch before exiting the vehicle.
Starting on a Hill
Unintentional roll-back of the vehicle could cause severe personal injury or vehicle dam-
age. To reduce the possibility of vehicle roll-back, keep the brake fully pressed until the
motor has started.
Do not use the accelerator and motor to hold the vehicle on a hill. Doing so for more than
3 - 4 seconds will cause permanent damage to motor.
To decrease the risk of permanent damage to the drive system, do not allow roll-back
when you start the vehicle on a hill.
1. Press the brake pedal with your left foot when releasing the parking brake. Keep pressure on the pedal to pre-
vent the vehicle from rolling back.
2. Press the accelerator pedal with your right foot as you release the brake pedal.
3. Press the accelerator pedal with gradual and steady pressure until the vehicle reaches the desired speed.
To Next Page
Loading...
Need help?
General
