10
6 Check before riding
P
lease check the following details before
riding.
Warning
If the vehicle is not properly
inspected and maintained, it will increase
the chance of accidents or damage to
components. Once any problem is found,
you must not ride the scooter. If the
problem cannot be solved in this manual,
please find the nearest service outlet
for repair and inspection.
Inspection steering handlebar
1. Turn on the power, operate the lighting
switch, check all the lights-High Beam,
Low Beam, Brake Light, Turn Signal
Indicator, etc.
Inspection of front and rear brakes
1.Use the front and rear brake handles
for braking, and check whether the braking
effect is normal.
2. Recommended brake fluid DOT4.
3. Check the front brake pads, if a brake
pad has worn to the point that the wear
indicator grooves were mostly disappeared,
have a dealer replace the brake pads
as a set.
tread height on the tire is less than 2mm).
If so, you should go to the after-sales
service department to replace the new
tires in time.
Inspection the Horn
Check whether the horn can work.
Inspection of reflectors and license
plates
1. Check the side reflector, and rear reflector
for dirt and damage. If there is, it should
be cleaned or replaced in time.
2. Check whether the license plate is installed
securely, the number is clear, and there
is no dirt and damage.
Inspection the battery
Check adequate for planned distance to
travel.
Inspection of tires
1. Check the tire pressure, the proper
pressure of front and rear tire is 280kpa.
2.Check the tire for cracks or openings and
excessive wear (the
To Next Page
Loading...