Press the clean water
tank cover to remove
it from the brush unit.
1/ Press the ON/OFF button to start the machine. The
default speed is the minimum speed. Press the ON/
OFF button again to turn o the unit.
2/ Press the Speed button to change the speed.
3/ Place the product on its storage base, plug it in
and press the ON/OFF button to start the automatic
cleaning of the roller brush.
Align the clean water
tank in the slots of the
brush unit and press
until you hear a «click».
Pull the roller brush
latch out and up to
remove it from the
brush assembly.
Align the first end of
the roller brush with
the slot and then put
the other end of the
brush in the slot of the
brush block to reinstall
the roller brush.
①
②
①
①
②
STARTING YOUR DEVICE
ON / OFF button and
automatic cleaning
Speeds
FILL THE TANK WITH CLEAN WATER
METHOD 1:
Open the cap of the
clean water tank.
Fill the measuring cup with clear, cold water.
Caution: Using warm or hot water may damage
the appliance.
Fill the tank with
clean water using the
measuring cup.
ENGLISH
To Next Page
Loading...
