4
1
2
4
3
5
6
7
8
Measure the door's thickness and select the appropriate screws.
Thickness Screw
35 to 60mm
60 to 85mm
85 to 105mm
2. Turn the screws into the back of
camera.
3. Tear off the release paper. 4. Pass screws and wire through the door.
You can roll up the paper to help
5. Adjust camera's position and
push it close to the door gently.
6. Take out the base, plug the
connector into the slot on the bottom
of the base and put the base cover on.
7. Pass screws through the mounting
holes.
8. Adjust the mouting base's
position and tighten the screws.
9. Put the wires in th groove and insert
the buckle.
10. Slide the panel into the mounting base.
11. Installation completed.
Remove the sticker.
To Next Page
Loading...
