3
Setup
Follow the steps to set your peephole:
1. Get the EZVIZ app, and log in to your EZVIZ app account.
2. Install your peephole and power on.
3. Power on your peephole.
4. Connect your peephole to the Internet.
5. Add your peephole to your EZVIZ account.
1� Get the EZVIZ App
1. Connect your mobile phone to Wi-Fi using your 2.4GHz network (suggested).
2. Download and install the EZVIZ app by searching “EZVIZ” in the App Store or Google Play
TM
.
3. Launch the app and register an EZVIZ user account.
EZVIZ App
If you have already used the app, please make sure that it is the latest version. To find out if an update is available,
go to the app store and search for EZVIZ.
2� Installation
2�1 Install the Micro SD Card (Optional)
1. Insert a Micro SD card (sold separately) into the SD card slot as shown in the figure below.
After installing the Micro SD card, you should initialize the card in the EZVIZ app before using it.
2. In the EZVIZ app, tap the Record List in the Device Settings interface to check the SD card status.
3. If the memory card status displays as Uninitialized, tap to initialize it.
The status will then change to Normal and it can store videos.
2�2 Install the Peephole
If you already have a peephole, install the device in the same place. If not, please drill a hole of diameter about
14mm (no more than 45mm) and about 145cm distance from the ground to have a good viewing effect.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
