Ezviz RH2 - 4� Clean the Rolling Brush and the Rolling Brush Cover; Faq

17
4� Clean the Rolling Brush and the Rolling Brush Cover
It is recommended to clean the rolling brush and the rolling brush cover after daily use.
If you want to clean the residual stains on the suction nozzle, please clean it with wet rag. Rinsing it with water is forbidden.
1. Put your nger on the position as shown in the gure, press
the release buttons on both ends of your thumb and index nger,
and lift them up, then take out the rolling brush cover.
2. Pull out the rolling brush handle at the right end of the
device with your index nger, pull out the rolling brush
handle with your hand, pull it outward, and take out the
rolling brush.
3. Use the other end of the provided cleaning brush to remove
the hair or debris on the rolling brush, and then rinse the rolling
brush with clean water.
4. Clean the rolling brush cover with the cleaning brush.
a
b
5. Please use the cleaning brush to clean the suction nozzle, and
use a wet rag to wipe the dirt on the suction nozzle (do not rinse
it with water).
6. After cleaning, insert the handle-free end of the rolling
brush into the corresponding drive cone, and then snap
the end with the handle into the slot on the right side to
absorb it, place the rolling brush cover back, and complete
the installation.
If there is water leakage or no water out of the rolling brush, please check the water-spraying channel and the suction
nozzle then clean the waste and dirty marks.
FAQ
Problem Cause Solution
No obvious dirt on the floor
while color of the icon of
intelligent mode is changing.
Dirty sensor is covered by dirt.
Restart the device after clean the blockage in tubes of
the suction nozzle.
The device is not working.
No power or low device battery. Please fully charge the device before use.
Rolling brush is wounded by the
objects like hair.
Clean the rolling brush.
Dirty water in the dirty water bucket
has reached to designated capacity.
Take out the dirty water bucket and dump the dirty
water for reuse.
Rolling brush and the dirty water
bucket are not installing properly.
Reinstall them.