FAAC 550 - CE Declaration of Conformity

550
ENGLISH
Guide for the installer
Page 5
Notes on reading the instruction
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol draws your attention to the notes on the characteristics and operation of the product.
CE DECLARATION OF CONFORMITY
Manufacturer: FAAC S.p.A.
Address: Via Calari, 10 - 40069 - Zola Predosa - Bologna - ITALY
Declares that: Operator mod. 550
is built to be integrated into a machine or to be assembled with other machinery to create a machine under the provisions of Directive
2006/42/EEC;
conforms to the essential safety requirements of the following EEC directives:
2006/95/EC Low Voltage directive.
2004/108/EC Electromagnetic Compatibility directive.
and also declares that it is prohibited to put into service the machinery until the machine in which it will be integrated or of which it will
become a component has been identified and declared as conforming to the conditions of Directive 2006/42/EEC and subsequent
modifications.
Bologna, December 30, 2009
Managing Director
A. Marcellan
•
•
•
•
•
INDEX
IMPORTANT NOTES FOR INSTALLER page.6
1. DESCRIPTION (Fig. 1) page.6
2. TECHNICAL SPECIFICATIONS page.6
3. ELECTRICAL INSTALLATION LAYOUT(standard system Fig. 3) page.6
4. INSTALLING THE AUTOMATION SYSTEM page.6
4.1. PRELIMINARY CHECKS page.6
4.2. POSITIONING TELESCOPIC ARMS page.6
4.3. POSITIONING OPERATOR/BACK PLATE page.6
4.4. ASSEMBLY SEQUENCE page.7
4.5. ADJUSTING THE COUNTERWEIGHTS page.7
5. MOUNTING GEARED MOTOR UNIT page.7
6. START-UP page.7
6.1. CONNECTING ELECTRONIC CARD page.7
6.2. CHECKING DIRECTION OF ROTATION page.7
6.3. ADJUSTMENT OF LIMIT SWITCHES (OPTIONAL) page.7
6.4. MOUNTING COVER page.7
7. TESTING THE AUTOMATION SYSTEM page.7
8. MANUAL OPERATION page.7
9. RETURNING TO NORMAL OPERATION page.8
10. MAINTENANCE page.8
11. REPAIRS page.8