5
ENGLISH
1
2
4
3
5
2
3x0.5 mm
2
2x1.5 mm
2
2x1.5 mm
2
2x0.5 mm
2
2
3x1.5 mm
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2
Fig.1
Fig.2
617 AUTOMATED SYSTEM
The automated system consists of a steel upright with cataphoresis
treatment, painted with polyester paint. It contains the non-
reversing electro-mechanical operator and, in the versions with a
control unit, the electronic control equipment. The system has a
convenient manual release device for use in case of a power-cut
or malfunction.
The balancing spring and the beam (not supplied) must be
ordered with reference to the sales price list.
Attention: The automated system was designed and built for
controlling vehicle access. Do not use it for any other purpose.
1.DESCRIPTION AND TECHNICAL SPECIFICATIONS
Tab. 1 Technical specifications
(¹) Opening time and number of cycles calculated for correctly
effected installations at the dimensions indicated in the installation
instructions and without decelerations.
(²) No accessories can be fitted on beams of over 6 metres
2.ELECTRICAL EQUIPMENT LAYOUT (standard installation)
LEDOM716
)caV(ylppusrewoP 032
)W(rewoP 083
)A(tnerruC 7.1
)C°(noitcetorplamrehT 041
)Fµ(roticapaC 5.21
)mN(euqrot.xaM 051
)¹()ces(emitgninepO 8
)m(htgnelmaebxaM (7
2
)
C°02taycneuqerfesudnaepyT %06-3S
)¹(C°02taruoh/selcycevitacidnimuminiM 031>
)C°(erutarepmettneibmagnitarepO 55+02-
)gk(thgiewrotarepO 96
ssalcnoitcetorP 44PI
)mm(snoisnemidrotarepO 3.gifeeS
01 BEAM
02 MECHANICAL STOP
03 SPRING CARRIER ROD
04 LIMIT-SWITCH
05 ADJUSTABLE CAMS
06 MANUAL RELEASE
07 GEARMOTOR UNIT
08 SPRING PLATE
09 BALANCING SPRING
10 ELECTRONIC EQUIPMENT
11 BALANCE ADJSTMT.TIE-ROD
12 EARTH SECURING SCREW
13 FOUNDATION PLATE
14 TIE-ROD
15 DOOR
16 UPRIGHT
01 SPIN BARRIER
02 PHOTOCELLS
03 KEY-OPERATED SELECTOR SWITCH
04 FLASHING LAMP
05 RADIO RECEIVER
Notes:
1) to lay cables, use adequate rigid and/or flexible tubes.
2) always separate the low voltage connection cables for accessories
from power cables. To prevent any interference whatever, use separate
sheaths.
Power supply
To Next Page
Loading...
