What to do if FAAC B614 barrier does not open or close?
If your FAAC Control Systems barrier isn't opening or closing, there are a few things you can check. First, make sure the automation hasn't been released. Also, verify that the STOP LED is not active. Finally, check the motor and encoder connections.
How to fix FAAC B614 Control Systems barrier that does not close?
If the FAAC Control Systems barrier doesn't close, first ensure the automation is not released. Next, check the motor's direction of travel. Finally, verify that the LEDs for the controls, loops, safety devices, and EMER are not active.
General| Power Supply | 230 V AC (+6% -10%) 50 (60) Hz |
|---|---|
| Voltage | 230 V |
| Operating Temperature | -20°C to +55°C |
| Protection Class | IP54 |
| Power Consumption | 300 W |
| Protection Degree | IP54 |
| Output | 24 Vdc accessories power supply |
Guidelines for safe installation practices and personal protection.
Step-by-step guide for fixing the foundation plate.
Instructions for mounting the barrier housing onto the foundation.
Procedures for basic and advanced programming of the barrier's functions.
Procedure to memorize limit switch positions and configure the system.
Troubleshooting guide for common issues and their solutions.
Interpreting the status LEDs on the control board for diagnostics.
Schedule and procedures for regular maintenance of the automation system.
Step-by-step guide for operating the barrier manually.
Procedure for correctly balancing the barrier beam.
Table and guide for balancing rectangular beams based on length and accessories.
To Next Page
