B614 3 732998 - Rev.A
Translation of the original instructions
ENGLISH
TABLES
1 Symbols: notes and warnings on the instructions ......4
2 Symbols: safety signs (EN ISO 7010) ................... 5
3 Symbols: personal protective equipment ..............5
4 Symbols: markings on packaging .....................7
5 Symbols: markings on product.......................11
6 Technical data ......................................12
7 E614 board technical data ...........................32
8 Basic programming .................................38
9 Default speed ......................................39
10 Advanced programming ............................39
11 Orienting the photocells ............................47
12 Addressing control devices ..........................48
13 Routine maintenance ...............................54
14 Periodic replacements ..............................56
15 Troubleshooting ....................................57
16 Rectangular beam balancing ........................61
17 Round beam S balancing ............................62
ADDENDUM
1 Foundation for barrier in maximum configuration .....60
2 Balancing system ...................................61
Deleting radio controls from memory .................. 46
9.4 BUS 2easy devices ................................... 47
Connection ........................................... 47
BUS 2easy photocells .................................. 47
Control devices ....................................... 47
BUS 2easy device registration .......................... 48
9.5 Round beam light kit ................................ 49
9.6 Integrated flashing light ............................. 49
9.7 Beam joint kit ....................................... 49
9.8 Hedge .............................................. 50
9.9 Foot ................................................ 50
9.10 Fork ............................................... 50
10. MASTERSLAVE ..................................... 51
Connection ........................................... 51
Slave barrier configuration ............................ 52
11. DIAGNOSTICS ....................................... 53
11.1 LEDs check ......................................... 53
11.2 Direction of movement check ....................... 53
11.3 Encoder operation check ............................ 53
11.4 Automation system status check .................... 53
11.5 Check firmware version ............................. 53
11.6 Check of the registered BUS 2easy devices ............ 53
12. MAINTENANCE ...................................... 54
12.1 Routine maintenance ............................... 54
12.2 Spring replacement ................................ 56
12.3 Replacing the Gearmotor ........................... 56
12.4 Fuse replacement .................................. 57
12.5 Operational problems .............................. 57
13. INSTRUCTIONS FOR USE ............................ 58
13.1 Safety recommendations ........................... 58
13.2 Emergency use ..................................... 58
13.3 Manual operation .................................. 59
Release procedure .................................... 59
Operation restoration ................................. 59
To Next Page
Loading...
