FAAC B614 - Beam Lights; Integrated Flashing Light; XBAT 24 Battery; XF Radio Module

41
42
B614 36 732998 - Rev.A
BUS BUS GND LAMP OUT 4 OUT 3 OUT 2 OUT 1 +24V LAMP
PE
N
L
N
L
6 A
OPEN
1 2
3 4 5 6
+24V GND EMER STOP CLOSE LOOP 2 LOOP 2 LOOP 1 LOOP 1
XF 433-868
AC MAIN
ENC
TRAFFIC
LAMP
LIGHT
BEAM
COM
BLR
BLG
MOT
MOT
M
J1
BUS BUS GND LAMP OUT 4 OUT 3 OUT 2 OUT 1 +24V LAMP
PE
N
L
N
L
6 A
OPEN
1 2
3 4 5 6
+24V GND EMER STOP CLOSE LOOP 2 LOOP 2 LOOP 1 LOOP 1
XF 433-868
AC MAIN
ENC
TRAFFIC
LAMP
LIGHT
BEAM
COM
BLR
BLG
MOT
MOT
M
BUS BUS GND LAMP OUT 4 OUT 3 OUT 2 OUT 1 +24V LAMP
PE
N
L
N
L
6 A
OPEN
1 2
3 4 5 6
+24V GND EMER STOP CLOSE LOOP 2 LOOP 2 LOOP 1 LOOP 1
XF 433-868
AC MAIN
ENC
TRAFFIC
LAMP
LIGHT
BEAM
COM
BLR
BLG
MOT
MOT
M
J8
J7
Translation of the original instructions
ENGLISH
Li
The encoder must always be connected in order for
the automation system to operate.
BEAM LIGHTS
See § 9.5 and § 9.6 for the connection.
INTEGRATED FLASHING LIGHT
40 See § 9.6 for the connection.
XBAT 24 BATTERY
41 See § 9.2 for the connection.
XF RADIO MODULE
41 See § 9.3 for the activation.
MAINS SUPPLY AND EARTHING
Li
Use a 3G 1.5 mm
2
wire (not supplied).
!
The grounding between board and box is done in the
factory. Do not remove the connection.
1. Crimp the earth wire of the power cable to the
cable terminal provided.
2. (42) Insert 2 washers, the cable terminal and
the nut provided on the earth plug respecting the
insertion order.
3. Tighten the nut.
4. Connect the phase wires and neutral to J1.