What to do if my FAAC Engine motor, without set travel limits, does not accept remote control commands?
If your FAAC Engine motor, which does not have set travel limits, isn't responding to the remote control, the remote control may not be memorized. To resolve this, memorize the first remote control.
What to do if the FAAC Engine motor already has set travel limits but does not accept the remote control commands?
If your FAAC Engine motor already has set travel limits but isn't responding to remote control commands, here are a few potential reasons: * The sun sensor might be active. If so, turn off the sun sensor. * The remote control might be de-memorized. In this case, you should perform memorization of the first remote control. * If there are no other remote controls, totally delete the memory and follow the memorising procedure for the single remote control. * If there are other working remote controls, perform the procedure for adding remote controls and re-memorise (see remote control instructions)
Why does my FAAC T-Mode TM 45 Engine motor move briefly three times in both directions each time it receives a command?
If your FAAC Engine motor moves briefly three times in both directions each time it receives a command, it means that the motor is in advanced menu mode. To exit this mode, keep the stop/preferred position push-button pressed for 7 seconds.
Why does my FAAC T-Mode TM 45 motor perform three brief movements in both directions each time it is powered on?
If your FAAC Engine motor performs three brief movements in both directions each time it is powered on, it means that the motor is in advanced menu mode. To exit this mode, keep the stop/preferred position push-button pressed for 7 seconds.
To Next Page
General