X 1
x 1
P
x 2
P
ENGLISH
5
6 RESETTING THE TRAVEL LIMIT (the remote controls stay memorised)
RESET RESTORES THE MOTOR’S FACTORY CONFIGURATION. THIS CAN BE CARRIED OUT AT ANY TIME, EVEN DURING THE SET-UP
PROCEDURE.
1) Press the programming key twice for 2 seconds
2) Within 2 seconds, press the programming key again for 7 seconds
3) The motor will rotate briefly in both directions to confirm memorisation
Each pression
2 seconds
7 seconds
7 TOTAL DELETION OF THE RECEIVER (the travel limits stay memorised)
1) Cut off power to the motor, wait 10 seconds and connect the black wire with the brown one.
(If it features a “step-by-step” push-button, it is enough to keep it pressed without making the
connection).
2) Power the motor after about 10 seconds. The motor will turn in both directions for 1 second
indicating that the memory has been totally deleted.
3) Cut off power to the motor again. Disconnect the black (or red) and brown wire. (Release the “step-by-step”
push-button, if used)
SHOULD ALL THE MEMORISED REMOTE CONTROLS FAIL OR BE LOST, BEFORE IMPLEMENTING A NEW REMOTE CONTROL, IT IS
NECESSARY TO TOTALLY DELETE THE RECEIVER BUILT INTO THE MOTOR. THEN PERFORM THE MEMORISATION PROCEDURE OF THE
FIRST REMOTE CONTROL. THE SET TRAVEL LIMITS WILL NOT BE DELETED.
PROBLEM REASON SOLUTION
WHEN POWERED ON, THE MOTOR DOES
NOT MOVE
Already set travel limits
Should you wish to change the travel limits, reset as
described in chapter 6, and teach again (chap. 5)
THE MOTOR ALREADY HAS SET TRAVEL
LIMITS BUT DOES NOT ACCEPT THE REMOTE
CONTROL COMMANDS
Sun sensor on Turn off the sun sensor
De-memorised
remote control
Perform memorisation of the first remote control
If there are no other remote controls, totally delete the
memory and follow the memorising procedure for the
single remote control.
If there are other working remote controls, perform the
procedure for adding remote controls and re-memorise
(see remote control instructions)
CANNOT COMPLETE THE TRAVEL LIMIT
LEARNING PROCEDURE
I n c o r r e c t c o m m a n d
sending sequence
Reset the travel limit to restore the motor’s factory
settings.
(the remote controls will not be de-memorised)
MOTOR WITHOUT SET TRAVEL LIMITS,
DOES NOT ACCEPT REMOTE CONTROL
COMMANDS
Non-memorised
remote control Memorise the first remote control
C A NN O T A D D A N E W R E M OT E
CONTROL
Too many memorisable
remote controls (max 20)
Eliminate an old remote control and re-memorise the
new one
EACH TIME THE MOTOR IS POWERED IT
PERFORMS THREE BRIEF MOVEMENTS IN
BOTH DIRECTIONS
The motor is in advanced
menu mode
Exit from the advanced menu, keeping the stop/preferred
position push-button pressed for 7 seconds
EACH TIME THE MOTOR RECEIVES A
COMMAND, IT MOVES BRIEFLY THREE
TIMES IN BOTH DIRECTIONS
The motor is in advanced
menu mode
Exit from the advanced menu, keeping the stop/preferred
position push-button pressed for 7 seconds
8 TROUBLESHOOTING
RESET OK
To Next Page
Loading...
