EasyManuals Logo

Faber e-MatriX 800 User Manual

Faber e-MatriX 800
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
The e-MatriX Electric Fireplace offers an alternative to
a wood or gas fireplace.
Electrical
Volts 120 V
60 Hz
Amps
2.25 A @ 25
o
C
Watts
270 W @ 25
o
C
Wiring Hardwire
Bulb Type LED
Approvals
Batteries Remote
(2x) 1.5V AA
Water Consumption
0.30 l/hr
Inlet Water Pressure
8-110 psi
Water Connection
¼" water line or
¾" female
NOTE: A 15 A circuit is required. A dedicated
circuit is preferred, but not essential in all cases.
A dedicated circuit will be required if, after
installation, the circuit breaker trips or the fuse
blows on a regular basis when the heater is
operating. Additional appliances on the same
circuit may exceed the current rating of the
circuit breaker.
!
Product Dimensions
Four models are available for the Faber e-MatriX
Electric Fireplace:
FEF3226L1
FEF3226L2L
FEF3226L2R
FEF3226L3
Specications
FCC Compliance
CAUTION: This unit has been tested and found
to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This unit generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio or television
reception, which can be determined by turning the
unit OFF and ON, the user is encouraged to try
to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the unit and the
receiver.
Connect the unit into an outlet on a circuit di󰀨erent
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This unit complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This unit may not cause harmful interference, and
(2) this unit must accept any interference received,
including interference that may cause undesired operation.
FCC CAUTION: Any changes or modications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
this equipment.
Important Instructions

Other manuals for Faber e-MatriX 800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Faber e-MatriX 800 and is the answer not in the manual?

Faber e-MatriX 800 Specifications

General IconGeneral
BrandFaber
Modele-MatriX 800
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals