23
Troubleshooting
Symptom Cause Action
The ame eect will not start. Transducer is not installed properly Make sure the connectors are inserted
correctly.
e-MatriX will not start or stopped
working and the LEDs continuously
blink twice.
Low water level. See "Check Water Connections for
Leaks" on page 15.
The absorption valve is activated See "Resetting Absorption Valve" on
page 22.
e-MatriX will not operate, the LEDs
continuously blink once every eight
seconds.
Water level too high. Remove water from the sump so
that water is between high and low
water marks.
Check the electromechanical valve in the
Control box.
e-MatriX will not operate, the LEDs
continuously blink four times.
Water lling time is too long. Switch the mains switch of the Control
box to the OFF position. Check
connections for water leakage.
Close the ball valves. Unscrew the mesh
lter base and remove any dirt or debris.
The ame eect is too low on the
highest setting.
The transducers and/or air lter
are dirty.
See "Replacing Tranducers" on page 21
and/or "Cleaning Air Filter" on page 20.
Air ow is insucient. Check to make sure there is enough
airow to the bottom of the unit.
The ame eect is too high and
there is too much smoke.
The exhaust fan does not work. Make sure the fan, mounted at the top
inside the replace, is running.
Air lter is not in place. Ensure air lter is in correct position,
see page 20.
Remote is not working. Low batteries. Place new batteries.
Remote is not paired to receiver. See "Pairing Remote" on page 18.
Remote too far from control receiver See "Pairing Remote" on page 18.
To Next Page
Loading...
Need help?
General
