17
WARNING: The e-MatriX replace must be
installed properly before it is used.
CAUTION: Except for installation and cleaning
described in this manual, an authorized service
representative should perform any other servicing.
First Time Water Fill
1.
Make sure all ball valves are open.
2. Turn on the water supply
3. Press the Main button [ ] on the control box to
the ON position.
• If the water level is high enough, the flames will
automatically start after 45 sec.
• If the water level is not high enough the LEDs will
blink twice after 45 sec. Press the Main switch to
the OFF position, wait 5 sec and repeat the step
above. (This process may need to be repeated
several times).
Manual Control Panel
The manual controls for the e-MatriX fireplace are
located on the front of the control box (located behind
the access door after installation). Touch an icon
to activate.
Icon Description
A
O
|
Main switch: Toggle ON/OFF.
(1 beep will be heard.)
1
Press to activate (ON).
(1 beep will be heard.)
Press again to turn OFF.
2
Press to activate remote pairing.
The replace will start to beep and
LED will ash. To pair the remote
press any button on the remote
during this time. Pairing is compete
when the replace turns OFF.
3
Maintenance: For use by service
technician.
4
Press multiple times to reduce the
ame height.
5
Press multiple times increase the
ame height.
6
Press multiple times to reduce the
re crackling sound.
7
Press multiple times to increase the
re crackling sound.
Operation