Faber INCA - User Manual

INCA
Power Module Rangehood
• Installation Instructions
• Use and Care Information
READ AND SAVE THESE INSTRUCTIONS
The Installer must leave these instructions with the homeowner.
The homeowner must keep these instructions for future reference
and for local electrical inspectors' use.
READ THESE INSTRUCTIONS BEFORE YOU START INSTALLING THIS RANGEHOOD
WARNING: - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: Keep fan, filters and grease laden surfaces clean.
Always turn hood ON when cooking at high heat. Use high range setting on range only when necessary. Heat oil slowly
on low to medium setting. Don’t leave range unattended when cooking. Always use cookware and utensils appropriate
for the type and amount of food being prepared.
WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE
THE FOLLOWING: SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. If the flames do not go out immediately EVACUATE AND CALL THE FIRE DEPARTMENT.
NEVER PICK UP A FLAMING PAN - You may be burned. DO NOT USE WATER, including wet dishcloths or towels - a
violent steam explosion will result. Use an extinguisher ONLY if: 1. You know you have a Class ABC extinguisher, and
you already know how to operate it. 2. The fire is small and contained in the area where it started. 3. The fire department
is being called. 4. You can fight the fire with your back to an exit.
ALL WALL AND FLOOR OPENINGS WHERE THE RANGEHOOD IS INSTALLED MUST BE SEALED.
This rangehood requires at least 24" of clearance between the bottom of the rangehood and the cooking surface or countertop.
Overhead cabinets on both sides of this unit must be a minimum of 18" above the cooking surface or countertop. Consult the
cooktop or range installation instructions given by the manufacturer before making any cutouts. MOBILE HOME INSTALLATION
The installation of this rangehood must conform to the Manufactured Home Construction and Safety Standards, Title 24 CFR, Part
3280 (formerly Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280). Four wire power supply must
Version 11/98 - Page 1
LISEZ BIEN CETTE FICHE AVANT D'INSTALLER LA HOTTE
AVERTISSEMENT: - POUR RÉDUIRE LE RISQUE DE FEU: Gardez le ventilateur, les filtres ainsi que toute autre superficie
propre. Utilisez la hotte pour cuisson à haute température. N'utilisez le feu vif que si nécessaire. Chauffez l'huile
doucement. Surveillez toujours la cuisson. Utilisez toujours des casseroles de taille convenable pour la cuisson.
AVERTISSEMENT: - POUR PRÉVENIR LES BLESSURES EN CAS DE FEU SUIVRE LES RECOMMANDATIONS SUIVANTES:
ÉTOUFFEZ LE FEU avec un couvercle métallique et fermez le brûleur. Si le feu ne s'éteint pas tout de suite, QUITTEZ
LES LIEUX ET APPELEZ LES POMPIERS. NE TOUCHEZ JAMAIS UNE CASSEROLE EN FLAMMES. N'UTILISEZ JAMAIS
DE L'EAU ou un torchon mouillé pour éteindre le feu - ce qui pourrait causer une explosion de vapeur. N'utilisez un
extincteur que si: 1. Vous avez un modèle ABC et vous connaissez bien son mode d'emploi. 2. Le feu est petit et peu
répandu. 3. Les pompiers sont déjà prévenus. 4. Vous avez une sortie derrière vous.
TOUTE OUVERTURE DANS LE MUR OU LE PLANCHER À PROXIMITÉ DE LA HOTTE DOIT ÊTRE SCELLÉ
Gardez 24 po. de hauteur entre le bas de la hotte et la surface de cuisson. Les armoires au-dessus ne dépasseront pas 13 po.
de profondeur. Les armoires au-dessus de chaque côté devront être au moins à 18 po. au-dessus de la surface de cuisson.
Consultez la fiche technique avant de découper les armoires. L'installation de cette hotte doit être conforme aux Réglements
de Manufactured Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for
Mobile Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for Mobile Home
Construction and Safety, titre 24, HUD, Section 280). Le branchement électrique se fait avec une raccordement à 4 fils. Consultez
la fiche technique électrique.

Summary

Introduction and Safety

Instruction Handling

Installer must leave instructions with homeowner for future reference and inspection.

Grease Fire Safety

Warnings and procedures to prevent and handle range top grease fires.

Installation Requirements

Sealing openings and mobile home installation compliance.

Venting Requirements

Ductwork & Termination Guidelines

Use metal ductwork, minimum length, proper sealing, and terminate outside.

Venting Safety Warnings

Avoid attic termination, use correct caps, prevent airflow obstruction to prevent fire.

Electrical Requirements

Power Supply & Wiring Connection

Connect via fused disconnect, use copper wire, proper conduit connectors.

Electrical Safety & Grounding

Essential grounding, circuit protection, and safe operation practices.

Dimensions

Rangehood Profile and Cutout

Side view dimensions and required cabinet cutout dimensions (width and depth).

Rangehood Front;Top Views

Front and top view dimensions including overall width, height, and filter layout.

Installation

Tools, Parts, and Duct Calculation

Lists needed tools, supplied parts, and explains ductrun length calculation.

Wall and Rangehood Preparation

Steps for preparing the wall and rangehood for mounting.

Mounting, Wiring, and Ducting

Instructions for attaching the unit, electrical connection, and securing ductwork.

Recirculating Installation Note

Specific requirements for recirculating installations including filter kit.

Use, Care, and Maintenance

Control Panel and Operation

Explains the functions of the light, blower, and speed control buttons.

Operating and Cleaning Tips

Best practices for operation and cleaning filters/surfaces.

Light Replacement Procedure

Step-by-step guide to replace the fluorescent light diffuser.

Faber INCA Specifications

General

Control Type	Mechanical
Lighting	LED
Number of speeds	3
Number of lamps	2
Grease filter type	Aluminum