Faber MATRIX EG10 X A90 ACTIVE User Manual

EN
1
10
USE
Control panel
Button Function Display
A Turns the suction motor on and off at speed
one.
Displays the set speed
B Decreases the working speed. Displays the set speed
C Increases the working speed. Displays the set speed
D Activate intensive speed from any other speed,
including motor off. This speed is set to
operate for 6 minutes, after which the system
returns to the speed that was set before.
Suitable to deal with maximum levels of
cooking fumes.
Displays HI and the time remaining once very
second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor
and Lights), to turn the Activated Charcoal
Filter alarm On and Off.
FC+Punto (2 flashes)–Alarm On.
FC+Punto (1 flash)–Alarm Off.
E 24H function
Turns the suction motor on at speed one and
effects one 10 minute extraction every hour.
Displays 24 and the spot at the bottom right
flashes once every second, while the motor is
running.
It is disabled by pressing the button.
When the filters alarm is triggered, the alarm
can be reset by pressing and holding this button
for approximately 3 seconds.
These indications are only visible when the
motor is turned off.
FF flashes three times.
When the procedure terminates, the indication
shown previously turns off:
FG indicates the need to wash the metal
grease filters. The alarm is triggered after the
Hood has been in operation for 100 working
hours.
FC indicates the need to change the
activated charcoal filters, and also to wash the
metal grease filters. The alarm is triggered
after the Hood has been in operation for 200
working hours.
F Delay function
Activate automatic switch-off with a 30’ delay.
Suitable to complete elimination of residual
odours. Can be activated from any position,
and is disabled by pressing the button or
turning the motor off.
Displays the operating speed and the spot at
the bottom right flashes once a second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor
and Lights), to turn the Remote Control On and
Off.
IR+Punto (2 flashes)– Remote Control On.
IR+Punto (1 flash)– Remote Control Off.
G Turns the lighting system on and off at
maximum intensity.
H Turns the Courtesy Lighting on and off.
A
B
C
D
E
F
G
H

Faber MATRIX EG10 X A90 ACTIVE Specifications

General

Brand	Faber
Model	MATRIX EG10 X A90 ACTIVE
Category	Ventilation Hood
Language	English