14
CLEANING THE SLICER
GENERAL
The machine must always be accurately cleaned at least once a day, and more often if
necessary.
Always use protective gloves.
DISASSEMBLING THE MACHINE FOR CLEANING
Disconnect the plug from the mains;
Turn the gauge plate know to '0';
Remove the various components as described in the following paragraphs:
Unscrew (counterclockwise) the blade guard rod;
If the blade guard is blocked, press on the rod knob to move it a little;
Extract the rod and remove the blade guard using for this operation only the
side knobs.
Loosen and remove the two fixing screws with knurled head;
Remove the slice guard.
To clean the machine body and the blade use only a cloth damped with
water and biodegradable lathery detergent having 7-8 pH and at a
temperature not below + 30°C.
Do not clean the machine by using water or vapor spruìys or similar
systems.
WARNING:
Use scratch-proof and non-slip gloves to carry out the
following operations. Proceed carefully and pay attention to
what you are doing.
Danger of cutting!
To Next Page
Loading...
