fadini COMBI 740 - Page 6

M8 fixing nuts
Bronze washer
Gate spacer hinge
Enclosure sunk in the ground
Temporary installation of the leaf above the Enclosure with the Gate spacer
hinge (after having welded the plate with the ferrule to the gate - pg.23, Pic.13)
PIC. 11
!
Attention: when installing gates with two leafs it is important to align the two enclosures; this can be done by pulling a string
through the four holes (two per enclosure), as shown in Pic. 10.
PIC. 10
Alignment string
Hole to align with the string in order
to achieve perfect alignment
of the two enclosures
Fixing hole of the
alignment string
!
Attention: before securing the Enclosure with concrete, align the inner hole of the enclosure with the upper hinge (Pic.11) and make sure
the enclosure is perfectly levelled. The upper edge of the enclosure must be flush with the finished ground level.
0.0
Level
Level
Concrete
casting
The upper edge of the
Enclosure must be level
with the finished ground
level
!
Level
Hole for alignment
with upper hinge,
located inside the
Enclosure
Threaded bars for securing
Combi 740 to the
Enclosure
!
Inside the enclosure there is a hole
that must be aligned with the upper
hinge
The gate leaf can be installed even without the Combi 740: the Enclosure, as a matter of fact, is pre-set to receive the Gate spacer hinge which, once
secured inside of it, replaces the lower hinge of the leaf (Pic. 12).
PIC. 12
22
!
Before securing the enclosures, they must be
perfectly aligned, one in front of the
other; this can be done by pulling a string
through the four holes (two per enclosure).
English