Faema E92/A Compact - Accessing Engineer Programming; Accessing the Programming Function; Dose Setup Procedures

EnglishEnglish
engineer
user dose setup
press a key
service dose setup
press a key
engineer
*
*
Monday 11:00
Boiler pres. 1,20 bar
1. How to access the programming function
!
The ENGINEER programming functions can be performed
regardless of the position of the dip-switches by using
theENGINEER key
2. Programming
During the programming phase, the machine will issue a sound signal
(repeated every 10 seconds). A new menu will be displayed each time
the PROGRAM (32) key is pressed. The order of the messages is as
follows.
When one of the dose delivery keys is kept pressed down, (water,
coffee, right steam button) the selection number is displayed and the
programming of the dose is memorized.
In the case of cappuccino function NO, if a key on the first group on
the left is programmed, this dose is applied to the equivalent keys of
the other dispensing groups.
In the case of cappuccino function YES, by programming the keys on
the group on the left, the dose will be recorded on the equivalent keys
of the other delivery groups, but not on those of the group on the left
(cappuccino group) which will be programmed under user dose.
When one of the dose delivery keys is pressed (water, coffee, cappuccino,
milk), the number of the selection and the number of pulses (coffee
doses), the time of distribution (water, milk), the temperature in C°
(steam, only when the automatic function is applied) is displayed.
The above parameters can be changed using the + (34) or - (35)
keys,
If the previously pressed key (identificable by the flashing led) is pressed
again and kept pressed down, the programming is memorized.
By programming the delivery keys on the group on the right, with the
cappuccino function activated press key
444
(33). The messages
milk dose (distribution time) and start milk (delay in the distribution
of milk with respect to the coffee) will be displayed. Follow the previous
procedure if variations are required.
To access the programming function place the ENGINEER key on the
reader (7).
The machine will issue an audio signal and the following message will
be shown on the display:
To close the programming phase, place the ENGINEER key on the
readout (7) and the following will be shown on the display:
If the key is lost , the ENGINEER programming operations can be performed by positioning dip-switch 2=ON, dip-switches 1-3-4=OFF;
press the PROGRAM (32) key and keep pressed for a few second the message "technician" will be displayed and a sound signal issued.
To exit the programming functions, keep the PROG (32) key pressed down and the message boiler pressure is displayed again. Once
the operations have been completed, replace the dip-switches to their original positions.
!
31 32 33 34 35 36