2
4 5
9 10
1 3
1211
7
6
14
15 16
8
13
English
24 EN
SEQUENTIAL WASHING
Remove the filter holder
from the coffee group.
Using a brush, clean the
cover gasket.
Hold down the coffee circuit
washing key
(26) for a few
seconds.
The simultaneous washing
screen (preset mode) will
appear on the display.
to change sel.
to con¿rm
Use the “ +” (30) and “ -” (31) keys to pass to the Sequential
WashinJ cycle. The scrolling icons of the machine groups
will appear on the display.
GROUP 2 WASH
push
to confirm
to change sel.
to con¿rm
Con¿rm the washing mode
using the key
OK
; the screen
will display:
INSERT. FILTER
HOLDER
GROUP 1
push
to confirm
Insert the rubber disk into
the ¿lter-holder with its ¿lter.
Pour in a packet or dosing
cupful of detergent powder.
Press the coffee circuit wash
key
(26).
Press the coffee circuit wash
key
(26).
GR1 WASH
The Group 1 wash cycle will
start and the "GR WASH"
message will appear on the
display.
At the end of the group 1
wash cycle, the message
"REMOVE FILTER HOLDER
GROUP " will appear.
REMOVE FILTER
HOLDER
GROUP 1
push
to confirm
GR1 RINSE
The message "GR RINSE"
will appear.
At the end of the group 1
rinse cycle, the message
"EXECUTE GROUP
WASH" will appear.
Remove the ¿lter holder.
Repeat the operations
described above for all
machine groups.
Do not remove the ¿lter holder
during coffee dispensing.
Hook the filter holder to
Group 1.
02_EmblemaR_1442.indd 24 21/10/2014 09:41:44
To Next Page
Loading...
Need help?
General
