94
THE FAULT INDICATOR LIGHTS
Your Washing Machine is equipped with a built-in fault detection system, indicated by a combination
of ashing wash operation lights. The most common failure codes are shown below.
(*) See the chapter regarding maintenance and cleaning of your machine.
Display
indication
Reason Explanation
E01 The door of your machine
is not shut properly.
Shut the door properly until you hear a click. If your machine persists
to indicate fault, turn off your machine, unplug it and contact the
nearest authorised service agent immediately.
E02 The water pressure or
the water level inside the
machine may be low.
Check the tap is fully turned on. Mains water may be cut-off. If the
problem still continues, your machine will stop after a while automat-
ically. Unplug the machine, turn off your tap and contact the nearest
authorised service agent.
E03 The pump is faulty or
pump filter is clogged or
electrical connection of
the pump is faulty.
Clean the pump filter. If the problem persists, contact the nearest
authorised service agent. (*)
E04 Your machine has exces-
sive amount of water.
Your machine will discharge water by itself. Once the water has
drained, turn off your machine and unplug it. Turn off the tap and
contact the nearest authorised service agent.
To Next Page
Loading...
