8025/8030 CNC OPERATING MANUAL 9
6. EDITING
Creation, modification and checking of blocks, programs and subroutines.
7. INPUT-OUTPUT
Transferring programs or machine-parameters from/to peripherals.
8. TOOL OFFSETS/ G53-G59
Input, modification and checking of the dimensions (radius and length) of up to
100 tools and of zero offsets (G53-G59).
9. SPECIAL MODES
- General testing of the CNC.
- Verification of inputs and outputs.
- Setting of decoded M functions.
- Setting of machine-parameters.
- Input of values for leadscrew error compensation.
- Operate with the PLC.
By means of these operating modes it is possible to program the CNC, produce parts in a
continuous run, work block by block and work manually.
Sequence for obtaining these operating modes:
- Press OP MODE: The list of 10 modes will appear on the screen.
- Press the number of the desired operating mode.
To Next Page
Loading...
