8025/8030 CNC OPERATING MANUAL 11
3.1.1.3. Selection of the first block to be executed
Once a program has been selected, the number of the first block to be executed appears to the
right of the program number.
If you wish to begin with a different block, the following procedure should be followed:
- Press the N key
- Key in the number of the block
- Press RECALL
The new number is displayed on the screen together with the contents of this block and those
of the subsequent blocks.
3.1.1.4. Display of the contents of the blocks
To display the contents of the blocks prior or subsequent to those appearing on the screen:
- Press : The previous blocks are displayed
- Press : The next blocks are displayed
Atention:
The program always starts with the block whose number appears to the right
of the program number, regardless of which ones are displayed on the screen.
To Next Page
Loading...
