8025/8030 CNC OPERATING MANUAL 13
3.1.1.7. Changing the operating mode
It is possible, at any time during the execution of a cycle in AUTOMATIC mode, to switch
to SINGLE BLOCK mode or vice versa. To do so:
- Press OP MODE. The listing of operating modes will appear on the screen.
- Press 1/0 (depending on the execution mode).
If any number other than 1/0 is pressed, the CNC returns to the previous position.
3.1.2. Display Modes
The display modes in AUTOMATIC or in SINGLE BLOCK are:
. STANDARD
. CURRENT POSITION
. FOLLOWING ERROR
. ARITHMETICAL PARAMETERS
. SUBROUTINE STATUS
. GRAPHICS
. EDITOR (BACKGROUND)
. PLC/LAN
. TOOL COMPENSATION
. TOOL INSPECTION
. PLC MESSAGES
3.1.2.1. Selection of display mode.
By pressing the function keys (F1/F7), placed under the screen, the user can select the desired
mode which appears displayed just above the corresponding function key.
By means of the [ETC] key, other function keys which are not displayed can be accessed.
To Next Page
Loading...
