18 8025/8030 CNC OPERATING MANUAL
3.1.3. Programming while running a program. BACKGROUND.
The CNC allows the edition of a new program while it is running a cycle in AUTOMATIC
mode or in SINGLE BLOCK mode. For this:
Press the function key [BACKGROUND EDIT]
The P ----- program number which appears corresponds to the number of the last program
which was edited.
If the OP MODE key is pressed, we return to the Standard Display Mode.
The remaining operations are identical to those in the EDITOR (6).
Atention:
It is not possible to work (edit, correct, etc.) with the program which is being
run. It is recommended to give programs numbers which have not been
previously stored in the memory, as if the programme which is being run
contains calls to subroutines of other programs, there could be problems.
Specifically the 001 error may be generated. During an editing operation, the
AUTOMATIC mode controls and keys or those of the SINGLE BLOCK
mode remain active.
3.1.4. PLC/LAN mode.
When the [PLC] function key is pressed, access is gained to the main menu of the PLC and
the LOCAL AREA NETWORK without any need for stopping the execution of the program.
(See the FAGOR PLC 64/INTEGRATED manual).
If the OP MODE key is pressed, we return to the STANDARD Display Mode.
To Next Page
Loading...
