22 8025/8030 CNC OPERATING MANUAL
3.2. MODE 2: PLAY-BACK
This method of programming is basically the same as the EDITOR mode, except with regard
to programming the values of the coordinates.
It allows the machine to be operated manually and the coordinate values reached to be entered
as program coordinates. The execution of a program requires the following steps:
3.2.1. Selection of the operating mode PLAY-BACK
- Press OP MODE
- Press key 2
The meaning of the function keys to operate in this mode will appear on the screen.
3.2.2. Locking/Unlocking of memory
Same as section 3.6.2. in EDITING mode.
3.2.3. Deletion of a complete program
Same as section 3.6.3. in EDITING mode.
3.2.4. Change of program number
Same as section 3.6.4. in EDITING mode.
3.2.5. Display and search of memorized subroutines
Same as section 3.6.5. in EDITING mode.
3.2.6. Selection of a program
Same as section 3.6.6. in EDITING mode.
To Next Page
Loading...
