24 8025/8030 CNC OPERATING MANUAL
3.3. MODE 3: TEACH-IN
This method of programming is basically the same as the EDITING mode, except that the
blocks which are written may be executed before being entered into memory. This enables a
part to be produced block by block while it is being programmed.
The execution of a program requires the following steps:
3.3.1. Selection of the operating mode TEACH-IN (3)
- Press OP MODE
- Press key 3
The meaning of the function keys to operate in this mode will appear on the screen.
3.3.2. Locking/Unlocking of memory
Same as section 3.6.2. in EDITING mode.
3.3.3. Deletion of a complete program
Same as section 3.6.3. in EDITING mode.
3.3.4. Change of program number
Same as section 3.6.4. in EDITING mode.
3.3.5. Display and search of memorized subroutines
Same as section 3.6.5. in EDITING mode.
3.3.6. Selection of a program
Same as section 3.6.6. in EDITING mode.
To Next Page
Loading...
