8025/8030 CNC OPERATING MANUAL 25
3.3.7. Creation of a program
Same as section 3.6.7. in EDITING mode except that the block may be executed before
pressing ENTER. To do this:
- Press . The CNC executes the block.
- If it is correct, it may be recorded in memory by pressing ENTER.
- If it is incorrect, press DELETE.
- Rewrite the block.
Atention:
On pressing , the CNC executes the block and the display mode
changes to AUTOMATIC mode.
By pressing ENTER or DELETE the display returns to the TEACH- IN
display mode.
When the blocks are executed, the CNC retains the sequence of the completed
blocks.
Radius compensation cannot be performed in this mode.
If a subroutine is called, the CNC will execute all its blocks.
In machining centers, when M06 is programmed, the CNC will execute all
the movements associated with tool change.
3.3.8. Deletion of a block
Same as in EDITING mode (6).
3.3.9.Copy a program.
Same as in EDITING mode (6).
To Next Page
Loading...
