can be controlled by mobile application.
Note:
• Touch -
tion, or touch to adjust the settings.
•
menu will be displayed.
• No operation for 30 seconds, the appli-
ance enters Standby mode.
• To immediately exit from the menu and
switch the appliance to standby mode
touch and .
touch and hold the sensor. Then touch the
sensors select one of the following:
Touch to make your selection and then
touch
Available connection modes:
• -
vice directly to the oven without the use
of any home wireless network devices.
•
access from outside this network is not
possible.
•
can be accessed from anywhere in the
world.
Note: Active connection is indicated on the
OPERATION
the mobile app.
Please visit
com
Error Codes: When there is a connection fail-
Error Reason Solution
E20
Connection
error
Try to reconnect
and, if unsuccessful,
contact your net-
work administrator
E21
Number
of users
exceeded
The appliance
stores all users
who connect by
Wi - to erase the
list, disconnect the
appliance from the
power supply and
reconnect again.
• Make sure that the oven is connected to
the power supply.
•
• In LAN mode, make sure that your mo-
bile device is connected to the same
-
nected to.
• In WAN mode, make sure the Internet
-
work.
• In LAN and WAN mode, you will need
a password (if exist) to connect to your
51
To Next Page
Loading...
