TROUBLESHOOTING
In the event of any fault:
•
• disconnect the power supply,
• based on the instructions given in the table below, some minor issues can be corrected
customer service.
Problem Reason Remedy
1. The appliance does not
work
No power Check the fuse, replace if
blown
work.
Loose or damaged bulb Replace the blown bulb (see
Cleaning and Maintenance sec-
tion)
3. The programmer display
shows “0:00”.
The appliance was discon-
nected from the mains or
there was a temporary
power cut.
Set the current time
(see ‘Use of the programmer’)
Risk of overheating! Immediately unplug the appliance or
nearest service centre.
If the problem is not solved, disconnect the power supply and report the fault.
Important!
75
To Next Page
Loading...
