Conversational mode
106
Description of the conversation mode standard
screen.
1. Softkey for selecting units mm/inches.
2. Softkey to go into tool inspection.
3. Softkey to access the graphics in execution mode.
4. Softkey for selecting offsets.
5. Softkey for tool calibration.
6. Window that displays information on the selected
tool.
7. Window that displays information on the feedrate of
the axis that is selected.
8. Window that displays information on the spindle.
9. Softkeys for cycle editing.
10. Message bar.
11. Real spindle rpm.
12. Position (coordinates) of the axes. The symbol
indicates that the axis is working in diameters.
If there are more than one spindle in the active channel,
S may be pressed repeatedly to select the spindle
whose data is being displayed. If the cell for
programmed turning speed is already selected, every
time S is pressed, it will show the data of the next
spindle.
Pressing the [DEL] key removes the program found on
the header (Program selected for execution). This
prevents program execution from commencing if the
[START] key is pressed.
To Next Page
Loading...
