Conversational mode
113
Saving a cycle.
After editing a cycle, it can be saved by pressing the
vertical softkey [Save cycle].
The saving screen displays the following softkeys:
1. Softkey to start simulating the selected program.
2. Softkey to start executing the selected program.
3. Softkey to create a new program.
4. Softkey that changes the horizontal softkey menu.
After pressing this softkey, the following softkeys
appear:
• Open program
• Operat. with blocks
• Undo/Redo
• Insert rect. pocket
5. Replace or insert the edited cycle. To insert a cycle,
move the cursor and the cycle will be inserted below
it.
6. Window that shows the cycles and ISO-coded blocks
that make up the selected part. To edit a cycle, press
[RECALL] with the cursor over the cycle.
7. Message bar.
8. Window showing the list of saved programs. In in this
window, it is possible to move through the list of
programs. When selecting a program, the right window
will show its contents. To change the working folder,
press [RECALL] while the focus is on the list and a
folder explorer will open to choose the new folder.
To toggle the focus between the list of programs and the
part editor, press [CTRL]+[F2] or the change window
key.
PROGRA M
PROGRAM
PROGRAM
1
2
3
4
5
7
8
6
To Next Page
Loading...
