Conversational mode
114
Simulation and execution of a part program
Simulation and execution of a part program.
Follow these steps when simulating or executing a part
program:
• Press [EDIT] to access the list of part-programs stored.
• Select on the left column the program to be simulated
or executed.
• Press the vertical softkey "Graphic simulation" or
"Execute program".
To toggle the focus between the list of programs and the
part editor, press [CTRL]+[F2] or the change window
key.
Note: with the cursor in the program section (right side),
by pressing F11 + Execute, with a START it will launch
the execution of the part-program from the block where
the cursor is located.
Simulate:
Execute:
[START]
+
+
To Next Page
Loading...
