Conversational mode
115
Offsets table
Offset table (zero and fixture offset).
In jog mode, it is possible to save the active offset in the
zero offset table or in the fixture offset table (zero offset,
coordinate presetting, etc.) and to activate a zero offset
already defined in the tables.
This softkey shows the zero offsets and the fixture
offsets of the system and their value in each axis of the
channel. This list is a brief information of the zero offset
tables and fixture offset tables and any change made in
jog mode also affects those tables.
Loading a new zero offset or fixture offset into the
table.
With an active offset, use the cursor to select an offset
from the list and press [ENTER] to save the current
offset in that zero offset. The position of all the axes of
the channel are updated at the selected zero offset.
Applying a zero offset or fixture offset stored in the
table.
Use the cursor to select a zero offset or fixture offset
from the list and press the [START] key to save it. The
new zero offset is applied to all the axes of the channel.
To Next Page
Loading...
