Conversational mode
116
Tool calibration
Tool calibration.
The softkey to access tool calibration will be different
depending on the software installed (lathe model or mill
model). To quit the calibration mode and return to jog
mode, press the [ESC] key.
The CNC offers in both models the possibility to
calibrate lathe tools and milling tools. The CNC will show
the necessary data and will update the help graphics
according to the selected tool.
There are several ways to calibrate a tool. Some ways
are only available when using a table-top probe.
Only manual calibration is possible when not using a
table-top probe. All types of calibration are available
when using a table-top probe. The different calibration
methods may be selected from the vertical softkey
menu.
To Next Page
Loading...
