13
Jog mode
Softkey Meaning
Description of the manual mode screen.
Change the units for data display (mm or inches). For
programming, the CNC assumes the units defined with
the active function G70 or G71, or, when not
programmed, the units set by the machine
manufacturer (INCHES parameter).
Setting and activating the zero offsets and the fixture
offsets. This softkey shows the zero offsets and the
fixture offsets of the system, either to store the active
zero offset or to activate a new zero offset.
Tool calibration / measurement (·M· model).
Tool calibration / measurement (·T· model).
Part centering (·M· model).
WORK MODES
To Next Page
Loading...
