Work modes
26
Part centering (mill model)
Part centering is available in the jog mode. This option is only
available at the mill model. To quit the part centering mode and
return to jog mode, press the [ESC] key.
Accessing part centering.
This mode may be used to calculate the center of a
rectangular or circular part of known dimensions as well
as, in rectangular parts, the inclination of the part with
respect to the abscissa axis. The type of part to be
centered is selected with the parameters of the cycle.
Type of part to be centered.
• Rectangular boss.
• Circular boss.
• Rectangular pocket.
• Circular pocket.
Cycle equivalent to part centering.
To execute this cycle, the probe must be properly
calibrated. Before executing the cycle, the probe must
be placed near the part and in front of the probing point,
as centered as possible and in the Z coordinate where
probing will take place.
To Next Page
Loading...
