Work modes
27
MDI / MDA mode
Edit new blocks.
• In MDI mode, the edit line is always visible.
• In MDA mode, one must select the "new block" option
from the softkey menu.
Modify a block from the block history.
• In MDI mode, use the [][] keys to display the history
and scroll through it. The [ENTER] key restores from
the history the block selected with the cursor and insert
it in the edit line.
• In MDA mode, use the [][] keys, select a block from
the history and use the "modify" option from the
softkey menu (or the [ENTER] key) to copy it into the
edit line.
Execute blocks.
• The [START] key executes the block currently
displayed on the editing line. Once the block has been
executed is saved in the block history. The [START]
key also directly executes the line where the cursor is
located on the history, if this line is not e be modified.
• The [STOP] key interrupts the execution of the block.
Press [START] again to resume execution from where
it was interrupted.
• While the execution is interrupted, the “CANCEL”
softkey cancels the execution of the block while
keeping the programmed machining conditions (it
does not do a general reset of the CNC).
• The [RESET] key cancels the execution of the block
and resets the CNC to its initial conditions.
To Next Page
Loading...
