ISO language
62
G202
* * Cancellation of additive manual
intervention.
G202 #AXIS [X ~ W, ... ]
Example: G202 #AXIS [X]
Note: cancels the additive manual intervention
of the selected axis; if only the function G202 is
programmed it will cancel the manual
intervention for all axes.
G261
* * Arc center in absolute coordinates
(modal).
See:
G06
G262
G261
Note: when this function is active, the CNC
interprets that the coordinates of the arc center
are defined by the origin of active reference
system.
G262
* * Arc center referred to starting point.
See:
G06
G261
G262
Note: when this function is active, the CNC
interprets that the coordinates of the arc center
are referred to the starting point of the arc.
G263
* * Arc radius programming.
See:
G02/G03
G263=...
...: Arc radius
Note: the arc radius is defined with the letter "R"
or by using assignments "R1=<radius>" or
"G263=<radius>".
G264
* * Cancel arc center correction.
G264
Note: if the difference between the initial radius
and the final radius exceeds the tolerance, then
the corresponding error will be displayed.
G265
* * Activate arc center correction.
G265
Note: the arc center is recalculated to make the
initial radius and the final radius the same.
Function M D V Meaning
To Next Page
Loading...
