ISO canned cycles (M)
74
G210
* * Bore milling canned cycle.
G210 [Z] [D] I [J] [K] B
Z: Reference plane
If not programmed, it assumes as reference
plane the current position of the tool
D: Safety distance (default = 0)
I: Machining depth
It may be programmed either in absolute or
incremental coordinates, in which case it will
be referred to the reference plane
J: Hole diameter
K: Pre-drilling diameter
B: Profiles
Note: the tool must meet the following
conditions:
- The tool radius must be smaller than K/2.
- The tool radius must be equal to or larger than
(J-K)/4.
Function MDVMeaning
To Next Page
Loading...
