ISO canned cycles (M)
75
G211
* * Inside thread milling cycle.
G211 [Z] [D] I J K B [C] [L] [A] [E] [Q]
Z: Reference plane
If not programmed, it assumes as reference
plane the current position of the tool
D: Safety distance (default = 0)
I: Machining depth
It may be programmed either in absolute or
incremental coordinates, in which case it will
be referred to the reference plane
J: Thread diameter
K: Thread depth
B: Thread pitch
C: Type of threading
- When programming C= 0, the threading will
be done in a single pass
- When programming C=1, it will make one
thread per each pass (single-edge cutter)
- When programming C=n (where n is the
number of cutting edges of the cutter), it will
make n threads per pass (default = 1)
L: Finishing stock allowance for finishing
(default = 0).
A: Maximum penetration pass
E: Approach distance
Q: Thread entry angle (default = 0)
Function MDVMeaning
J
Z
D
I
B
K
L
A
G00
G01
M03
M04
G98
G99
To Next Page
Loading...
