Why does my Fagor Hob switch itself off?
Your Fagor Hob might be switching off because no sensor field is touched for 10 seconds after activating the appliance. To prevent this, switch on the appliance and set the heat setting without delay. Alternatively, the sensor fields might be covered or dirty, so uncover or clean them.
What to do if sensor fields of my Fagor Hob do not respond?
If the sensor fields on your Fagor Hob aren't responding, it could be due to several reasons: * The appliance is not turned on: Make sure to turn on the appliance. * The sensor field is touched too briefly (less than one second): Touch the sensor field longer. * Multiple sensors are touched at the same time: Always touch only one sensor field (except when a cooking zone is switched off).
What to do if my Fagor Hob doesn't respond and beeps?
If your Fagor Hob is not responding and emits an extended beep, it could be due to improper use, such as touching the wrong sensor fields or touching them too briefly; in this case, reconnect the hob. Another possibility is that the sensor fields are covered or dirty, so uncover or clean them.
Why is residual heat indicator extinguished on my Fagor PBP3VE201FTQN?
The residual heat indicator on your Fagor Hob might be extinguished even though the cooking zones are hot because of a power outage or the appliance has been disconnected. The residual heat indicator will be shown again the next time the appliance is turned on and off again.
What to do if hob cooking surface of my Fagor PBP3VE201FTQN is cracked?
Immediately unplug the appliance or switch off the main circuit breaker. Refer the repair to the nearest service centre.
What to do if the problem with my Fagor PBP3VE201FTQN is still not remedied?
Immediately unplug the appliance or switch off the main circuit breaker (fuse). Refer the repair to the nearest service centre. Important! You are responsible for operating the appliance correctly and maintaining its good condition. If you call service as a result of operating the appliance incorrectly you will be responsible for the costs incurred even under warranty. The manufacturer shall not be held liable for damage caused by failure to follow this manual.
Why does my Fagor PBP3VE201FTQN appliance switch itself off?
Your Fagor Hob might be switching off automatically because no sensor field has been touched for 10 seconds after the appliance was activated. Try switching on the appliance and setting the heat setting without delay. It can also happen if the sensor fields are covered or dirty, so uncover or clean them.
What to do if sensor fields on my Fagor PBP3VE201FTQN do not respond when touched?
If the sensor fields on your Fagor Hob aren't responding, it could be due to several reasons: * The appliance might not be turned on, so ensure that it is. * You may be touching the sensor field too briefly (less than one second); try touching it longer. * You might be touching multiple sensors simultaneously; always touch only one sensor field at a time (except when switching off a cooking zone).
What to do if my Fagor PBP3VE201FTQN appliance does not respond and emits an extended beep?
If your Fagor Hob isn't responding and is emitting an extended beep, it could be due to improper use, such as touching the wrong sensor fields or touching them too briefly. Try reconnecting the hob. Another cause might be that the sensor fields are covered or dirty, so uncover or clean the sensor fields.
Why does a single cooking zone on my Fagor Hob switch off and show the residual heat indicator „H”?
A single cooking zone on your Fagor Hob might switch off and display the residual heat indicator “H” because of a limited cook time. Try switching the cooking zone on again. Also, this can happen if the sensor fields are covered or dirty, so ensure you uncover or clean them.
To Next Page
General
