What to do if my Fagor 3VFT-40AS Hob sensor fields do not respond when touched?
If the sensor fields on your Fagor Hob aren't responding, it could be due to a few reasons. First, make sure the appliance is turned on. If it is, ensure you're touching the sensor field for at least one second. Also, only touch one sensor at a time, except when switching off a cooking zone. Touching multiple sensors simultaneously can prevent them from working.
Why does my Fagor 3VFT-40AS appliance not work?
If your Fagor Hob isn't working, the most likely cause is a lack of power. Check the fuse and replace it if it's blown.
What to do if my Fagor 3VFT-40AS appliance does not respond and emits an extended beep?
If your Fagor Hob isn't responding and is emitting a long beep, it could be due to improper use, such as touching the wrong sensor fields or not touching them long enough. Try reconnecting the hob. Alternatively, the sensor fields might be covered or dirty, so uncover or clean them.
Why does my Fagor 3VFT-40AS Hob switch itself off?
Your Fagor Hob might be switching itself off for a couple of reasons. If no sensor field is touched for 10 seconds after turning it on, it will switch off, so switch on the appliance and set heat setting without delay. Also, the sensor fields might be covered or dirty; in that case, uncover or clean the sensor fields.
What to do if a single cooking zone switches off on my Fagor 3VFT-40AS Hob?
If a single cooking zone on your Fagor Hob switches off and the residual heat indicator "H" is displayed, it could be due to limited cook time. Try switching the cooking zone on again. Alternatively, the sensor fields might be covered or dirty, so ensure they are uncovered and clean. Another possible reason is that electronic components overheated.
What to do if Fagor 3VFT-40AS cooking surface is cracked?
Immediately unplug the appliance or switch off the main circuit breaker. Refer the repair to the nearest service centre.
Why is the residual heat indicator extinguished even though the Fagor Hob cooking zones are hot?
If the residual heat indicator on your Fagor Hob is off even though the cooking zones are still hot, it's likely due to a power outage or the appliance being disconnected. The indicator should reappear the next time you turn the appliance on and off again.
What to do if the problem with my Fagor 3VFT-40AS Hob is still not remedied?
Immediately unplug the appliance or switch off the main circuit breaker (fuse). Refer the repair to the nearest service centre.
What to do if Fagor 3VFT-40AS does not respond and emits an extended beep?
If your Fagor Hob is emitting an extended beep and not responding, it could be due to improper use, such as touching the wrong sensor fields or not touching them long enough. Try reconnecting the hob. Alternatively, the sensor fields might be covered or dirty, so uncover or clean them.
Why does a single cooking zone switch off on my Fagor Hob?
If a single cooking zone on your Fagor Hob switches off and the residual heat indicator „H” is shown, it could be due to the limited cook time. In this case, switch on the cooking zone again. Alternatively, the sensor fields might be covered or dirty, so uncover or clean them. Overheating of electronic components can also cause this issue.
General| Type | Gas Hob |
|---|---|
| Number of Burners | 3 |
| Material | Stainless Steel |
| Ignition Type | Automatic |
| Gas Type | Natural Gas/LPG |
To Next Page
