Why does my Fagor Hob switch off by itself?
If your Fagor Hob switches off by itself, it could be because no sensor field has been touched for 10 seconds after activation. To resolve this, switch on the appliance and set the heat setting without delay. Alternatively, the sensor fields might be covered or dirty, so uncover or clean them.
What to do if sensor fields do not respond on Fagor 3VFT-40AS Hob?
If the sensor fields on your Fagor Hob aren't responding when touched, ensure the appliance is turned on. Also, make sure you're touching the sensor field for longer than one second. Avoid touching multiple sensors simultaneously, except when switching off a cooking zone; always touch only one sensor field at a time.
Why is residual heat indicator extinguished on my Fagor 3VFT-40AS Hob?
If the residual heat indicator on your Fagor Hob is extinguished even though the cooking zones are hot, it's likely due to a power outage or the appliance being disconnected. The residual heat indicator will reappear the next time the appliance is turned on and off again.
What to do if the problem with Fagor Hob is still not remedied?
Immediately unplug the appliance or switch off the main circuit breaker (fuse). Refer the repair to the nearest service centre.
General| Type | Gas Hob |
|---|---|
| Number of Burners | 3 |
| Material | Stainless Steel |
| Ignition Type | Automatic |
| Gas Type | Natural Gas/LPG |
To Next Page
