Why don't the sensor fields respond on my Fagor 3MFT-2AC Hob?
If the sensor fields on your Fagor Hob aren't responding to touch, here are a few things to check: * Ensure the appliance is turned on. * Make sure you're touching the sensor field long enough (more than one second). * Only touch one sensor at a time, except when switching off a cooking zone.
What to do if my Fagor 3MFT-2AC is beeping and not responding?
If your Fagor Hob is beeping and not responding, it could be due to improper use, such as touching the wrong sensor fields or not touching them for long enough. Try reconnecting the hob. Also, check if the sensor fields are covered or dirty; if so, uncover or clean them.
Why does my Fagor Hob keep switching itself off?
Your Fagor Hob may switch off automatically if no sensor field is touched within 10 seconds of activation. To prevent this, switch on the appliance and set the heat setting without delay. Also, ensure that the sensor fields are clean and uncovered, as dirt or obstructions can also cause the appliance to switch off.
What to do if a single cooking zone switches off on my Fagor Hob?
If a single cooking zone on your Fagor Hob switches off and the residual heat indicator 'H' is displayed, this could be due to a limited cook time. Try switching the cooking zone on again. Also, ensure that the sensor fields are clean and uncovered. It can also happen because of overheated electronic components.
Why is the residual heat indicator off on my Fagor 3MFT-2AC when the cooking zones are hot?
If the residual heat indicator on your Fagor Hob is off even though the cooking zones are hot, it may be due to a power outage or the appliance being disconnected. The indicator should reappear the next time you turn the appliance on and off.
General| Type | Gas Hob |
|---|---|
| Number of burners | 3 |
| Burner type | Standard |
| Ignition type | Automatic |
| Material | Stainless Steel |
To Next Page
